During the training, the participants visited the group to arrange a call center, research and development centers, production workshop, the participants said that through this training visit, the other fast Group's corporate culture, lean management, staff professionalism with a deeper understanding of each other soon Group Technology R & D investment, product quality control, after-sales service system construction with understanding. Participants said that the current visit and study, the other group soon have a new understanding, and trust each other more products faster, this is very good training visits, Hope Group to adhere to gone out of existence. Safety Training Week is running fast party group of service users yet another form, the Group will integrate a variety of services in the form of online and offline, adhere to convenient and efficient service concept, to provide users with the best quality service.

Since the fuel gas and the like require hot water boiler fuel and the fuel would have a certain amount of combustion exhaust gas, while improving the thermal efficiency of the boiler, the boiler to reduce pollution is an important issue. Condensing hot water boiler as a new hot water boiler, whether in the use of heat, or in the above exhaust emissions which are due to the performance of the conventional type boiler. Then condensing boiler and hot water boiler ordinary What is the difference?

Easy maintenance: There are movable smoke box doors in the front and back of the boiler, and there are observation holes and inspection holes in the rear of the boiler, which can be checked and cleaned up in the furnace. The manhole is set up on the furnace body, and the structural design takes the convenience of future repair and maintenance into full consideration.

Fangkuai boiler removal and its pre-start requirements to learn and understand the boiler, can be a variety of ways and forms, as long as they can master the relevant knowledge content, can be. So, for this purpose, and in order to have a comprehensive understanding and understanding of the boiler, next, the boiler will be studied, so that you can also obtain some new knowledge and good use of it. 1. Is there a requirement for the feed-in speed of the boiler before start-up? Before the boiler starts, if the boiler is hot water boiler, then, there are some requirements, its specific is: hot water boiler before the start-up water intake speed should not be too fast, winter Seasonal water intake time should not be less than 4 hours, other seasons are 2 to 3 hours, the initial influent speed should be slow. In the case of a cold boiler, the inlet water temperature should be in the range of 50 ℃-90 ℃. 2. How to remove the boiler? Boiler demolition, it is conditional, not all boilers can be carried out. If the boiler has been in use for more than 10 years, demolition is not allowed. In addition, the boiler removal steps and procedures are as follows: the boiler must be within the inspection period of validity or through the local boiler inspection office to pass the inspection-to the boiler location quality supervision bureau special facilities to handle the transfer Installation application-boiler new installation site quality supervision bureau special unit handling transfer notification-boiler inspection center installation inspection qualified-put into use. 3. Which boilers are normal pressure boilers? Why use high-temperature condensate? From a professional point of view, there must be hot water boilers in atmospheric boilers, but not low pressure steam boiler suppliers. However, not all hot water boilers are atmospheric boilers. When the conveying distance is close, the heating area is smaller or the required hot water temperature is not higher than 100 degrees Celsius, the atmospheric pressure boiler can be used. When the boiler is running, it is used to produce steam through industrial water and coal-based energy. When steam releases some of its heat energy, it becomes high-temperature condensing water. If high-temperature condensing water is recycled as boiler recharge water or secondary flash steam is used, the industrial water and fuel can be saved, and then the flue gas emission of boiler can be reduced. Therefore, high-temperature condensing water will be used in boilers.