The first reason is that the cost of modern heating can be saved. It is well known that people in many areas before the advent of condensing boilers had to rely on traditional boiler equipment for heating. Affected by the working principle, traditional boilers consume a large amount of energy to release a certain amount of heat. However, the condensing boiler has great difference from the traditional boiler in design mode and working principle, so using the condensing boiler with relatively large heat release can save the cost of heating by modern people to a certain extent.
The meeting also outstanding performance in 2016 was in recognition of outstanding dealers, Lu president called on everyone confidence, walk hand in hand, writing a new chapter in the rapid development of the fast side. After the meeting, the participants went to the factory, gas boiler laboratory site visit. Then, fast boiler dealers a VIP Tong Fu Australian business communication, to visit and learn advanced foreign technology. The meeting has come to an end, fast-party reseller partners to do with the group to explore strategic, content exchange, policy interpretation, experience sharing, so that the two sides closer together, you and the dealer is confident it can work together under the leadership of the party soon Group creating a potential win-win future.
Paper mill boiler application
Boiler welding, Why a T-joint, do not use pull side welding? The connection 3.7.2T-junction "technology to monitor the boiler safety regulations" TSGG0001-2012: not greater than the rated working pressure of 2.5MPa and a horizontal tubular boiler combustion boilers, flue gas temperature of the working environment is less than the pressure receiving member 600 ℃ connection, when the following conditions may be employed butt T-junction using the connection but not lap joint: 1, the weld joint type using full penetration, and the machined groove; 2, horizontal boiler combustion boiler shell, the furnace tube plate and connected to the cylinder insert structure should be used; 3, T-shaped joint connection site weld thickness is not less than the wall thickness of the tube plate, and which can be sealed back seam welded portion should seal welded, not welding portion can be sealed welding backing should be used, and to ensure penetration; 4, the weld joints connecting portion of the T-shaped ultrasonic testing according NB / T47013 "nondestructive Testing pressure equipment" the relevant requirements.
